GP1A073LCS0F【PDF 3/4 页】PHOTOINTER OPIC SLOT 5MM W/CONN

您好，
买卖IC网欢迎您。
请登录
免费注册

(Unit : mm)

1. It is recommended to mark the shear droop surface (punch side) of the mounting plate (metal plate) with "GP1A073LCS/HCS".

2. Mounting workability, shaking after mounting and mounting strength depend on the corner radius of the mounting plate and state of punching.

Determine the mounting dimensions after check on an actual machine.

3. General dimensional tolerances shall be ?.1mm.

I Recommended Mounting Hole Shape

GP1A073LCS/GP1A073HCS

7.7

7.5

8-R0.1

?.1

8-R0.1

?.1

Plate thickness : 1.6 mm

7.5

Plate thickness : 1.0 mm

Plate thickness : 1.2 mm

8-R0.1

?.1

General mounting type

7.7

7.5

Plate thickness : 1.6 mm

7.5

Plate thickness : 1.0 mm

Plate thickness : 1.2 mm

Reverse insertion

preventive type

12-R0.1

?.1

12-R0.1

?.1

12-R0.1

?.1

2.4

I Precautions for Operation

1. In this product, the PWB is fixed with a hook, and cleaning solvent may remain inside the case;

therefore, dip cleaning or ultrasonic cleaning are prohibited.

2. Remove dust or stains, using an air blower or a soft cloth moistened in cleaning solvent.

However, do not perform the above cleaning using a soft cloth with solvent in the marking portion.

In this case, use only the following type of cleaning solvent for wiping off;

Ethyl alcohol, Methyl alcohol, Isopropyl alcohol,

When the cleaning solvents except for specified materials are used, please contact us.

3. In order to stabilize power supply line, connect a by-pass capacitor of more than 0.01礔 between V

and GND near the device.

G As for other general precautions, please refer to the chapter "Precautions for Use".

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式